VEMS Home Products Documentation Wiki Webstore
WikiHome ProjectPage DocsPage UnderDevelopment MembersPage SiteIndex RecentChanges Preferences
History of MembersPage/MarteleurTim/Ignition
Older Newer
2006-01-05 10:25:07 . . . . MembersPage/MarcellGal [proposed h[0] is fine]
2006-01-04 03:42:13 . . . . MembersPage/MarteleurTim
2006-01-04 03:35:42 . . . . MembersPage/MarteleurTim [added config and tables]
2006-01-04 03:25:25 . . . . MembersPage/MarteleurTim
2006-01-04 01:24:12 . . . . MembersPage/MarcellGal [precise_idle=off and iac_sol_channel=disabled disables iac]
2006-01-03 04:12:03 . . . . MembersPage/MarteleurTim [should I disable iac in config if I don't hve one?]
2006-03-16 04:43:08 . . . . MembersPage/MarcellGal [half req_fuel to increase VE precision; conf mostly OK]
2006-03-16 04:43:08 . . . . MembersPage/MarteleurTim [req-fuel calculation]
2006-03-16 04:43:08 . . . . MembersPage/MarcellGal [file format problem]
2006-03-16 04:43:08 . . . . MembersPage/MarteleurTim [first config and tables with Q's?]
2006-03-16 04:43:08 . . . . MembersPage/MarcellGal [measure the white dot position]
2006-03-16 04:43:08 . . . . MembersPage/MarteleurTim [determine crankadvance?still unclear]
2006-03-16 04:43:08 . . . . MembersPage/MarcellGal [remove a sparkplug, rotate the engine]
2006-03-16 04:43:08 . . . . webcache-1.backbone.imelda.be [how to determine exact crank advance?]
2006-03-16 04:43:08 . . . . MembersPage/MarteleurTim [pic of outputside of crankpulley]
2006-03-16 04:43:08 . . . . MembersPage/MarteleurTim [Do you mean flywheelside?]
2006-03-16 04:43:08 . . . . MembersPage/MarcellGal [How does the engine look on the output side ?]
2006-03-16 04:43:08 . . . . MembersPage/MarteleurTim

Changes by last author:

Changed:
I want injector sequence h[0]= 2 8 4 1 0 0 0 0

I have connected FETdrivers A B C D to EC36pin 7 19 8 20

Q: Does this correspond with my config and tables?

I want injector sequence 1342,

I have connected FETdrivers (according to GenBoard/Manual/DigitalOut/Table )

* A (mask 01) EC36pin7 cyl1

* B (mask 02) EC36pin19 cyl2

* C (mask 04) EC36pin8 cyl3

* D (mask 08) EC36pin20 cyl4

so h[0]= 2 8 4 1 0 0 0 0

is fine, since h[0] is traversed backwards from element 3 ("config.alternate" lower nibble) to 0.