History of MembersPage/GergelyLezsak/StageZero
Older Newer
2005-07-07 14:17:59 . . . . MembersPage/GergelyLezsak [update, removed buylist (going to separate page)]
2005-06-26 09:53:53 . . . . MembersPage/GergelyLezsak
2005-06-25 13:25:45 . . . . MembersPage/MarcellGal [checked list]
2005-06-24 21:14:53 . . . . MembersPage/GergelyLezsak [some correction]
2005-06-24 21:14:52 . . . . MembersPage/GergelyLezsak [some correction]
2005-06-24 14:40:19 . . . . MembersPage/GergelyLezsak [Buy list included]
2005-06-24 14:25:25 . . . . MembersPage/GergelyLezsak [New page]


Changes by last author:

Changed:
These data are:

*VR signal -RPM (need to share with motronic)

*cam signal from ign wire -optional

*MAP (sensor installation needed)

*IAT (sensor installation needed)

*CLT (need to share with motronic! otherwise motronic will work even worse either at cold-startup or warmed engine)

*WBO2 (sensor installation needed).

----

These are now obsolete! I realised that it's really hard to split every signal for two computers (both mechanically and electrically). Now I skip this stage and go directly to Stage 1

Changed:
If I can successfully get/share those signals, I can watch original working parameters and ready to go to stage 1.
In fact car was running about 5 mins in this stage before started in stage 1 :)

----

Changed:
Tell me if I'm wrong with this.
Watched data are:

*VR signal -RPM (need to share with motronic)

*MAP (sensor installation needed) - motronic doesn't use it

*IAT (sensor installation needed) - motronic has separate at AFM

*CLT (could be shared with motronic, otherwise motronic will work even worse either at cold-startup or warmed engine) - worked roughly.

*WBO2 (sensor installation needed) - motronic doesn't use it

*TPS -simply replaced old switch. Motronic lives without it

*cam signal from ign wire - didn't connected to genboard

Added:
If I can successfully get/share those signals, I can watch original working parameters and ready to go to stage 1.
Deleted:
----

Buy list

Deleted:
* Wires and plugs -- got it (whole harness form junkyard)

* Fuses and housing -- got it (whole harness form junkyard)

* M18x1.5mm/thread nuts to weld into exhaust (for wbo2) -- got it

* MAP sensor (guess 2.5 bar is fine), some pressure hose and T-shape fork

* IAT sensor and some sort of mounting

* GenBoard himself :) and rescue kits or whatever I need to power up

* EC36-PCB

* EC18-PCB

* EC36-Wire

* EC18-Wire

* LCD

** and a pair of DSUB9, some cable

* ps2 extension cable

* USB to RS232 if your notebook has no RS232

* LM1815 chip for cam signal

* WBO2 sensor

** WBO2 connector

* EGT K-Thermocouple

** AD597 K-Thermocouple amplifier

* Anything else?