* has camhall inverter inside (since 2008-07-20)

* weak 2k7 pullup for NTC type MAT sensor

** when running Marcell's engine (with factory PTC, around 500 Ohm), MAT reading was 67C (but tested OK on bench)

wbo2 parameters:

* wbo2_pump_pw_zero=67

* wbo2_nernstdc_target=85

other:

* egt1_cal=4c

The config and tables used to run MembersPage/MarcellGal/PowerAndTraction

* beware that Marcell's cam-HALL is 360 degrees rotated,

** and use different ignition outputs (cyl1 is from stepperD and factory power output stage, cyl2,5 and cyl3,4 are 2x2 wasted spark transformer)

** verify on MembersPage/FabioAudi/IgnitionOutputs that it matches yours

* http://www.vems.hu/files/MembersPage/Fabio/Audi/FabioECUrunsMarcellsAudi.zip

** with the following Econoseal to motronic55 (3B) adapter: http://www.vems.hu/files/MembersPage/Fabio/Audi/