I have rebuilt an engine for my car, and I am working with an electro-optical Hengstler RI32 encoder. It gives 100 push-pull pulses per revolution on one channel, and 1 push-pull pulse on another.

Problem is, obviously, that cam sync assumes a 200+1 setup, not a 200+2. I have a working RPM signal now, by pretending it's a 100+1 setup, but my rpm is therefore 2x as high as it should be, and I keep getting a sec trig pos bad error even with the min and max set to 1 and 360.

Any suggestions most appreciated. It's still the same 2.5 liter side-cam 4 cylinder engine setup, it's just that PT is now on the crankshaft using the electro-optical hengstler encoder.