Changes by last author:
Changed:
|
Vems V3.3 PnP for Peugeot 106 GTI (dp-engineering)
Vems Serial Number 1869 |
| Vems V3.3 PnP for Peugeot 106 GTI (dp-engineering) Serial Number 1869 |
| VemsTune runs in VMware Fusion on MacbookPro (had no problems at all until now / tried different laptop and in different car too) |
| VemsTune runs in VMware Fusion /Parallels on MacbookPro |
| Planned: VEMS Upgrade EGT, removable SD-Card, Knock-Sensor |
|
At the moment I have a serious problem with my Vems. The car ran fine but recently after a short trip (note: NOT after an attempted firmware upgrade) I could not start it anymore.
After connecting the Vems to the laptop i got the following error message: "Boot mode detected." (Choose Stay for firmware upload ....) *1) |
|
----
2014 My Firmware AND Bootloader Problems are solved. I build a bsd cable and rent an old laptop with parallel port. Then I've tried to flash with avrdude and got the failure message "Device signature = 0xffffff" ... "Invalid device signature". But with the parameter -F it was possible to overwrite the check and the upload and validate worked well! The vems now knows the serialnumber (yeah!) again and I was able upload the firmware i used at last by serial connection. AND most important: All settings and so on stay there after powering off! Thanks to Marcell for Support!
---- 2013 At the moment I have a serious problem with my Vems. The car ran fine but recently after a short trip (note: NOT after an attempted firmware upgrade) I could not start it anymore. After connecting the Vems to the laptop i got the following error message: "Boot mode detected." (Choose Stay for firmware upload ....) *1) |
