VEMS Home Products Documentation Wiki Webstore
WikiHome ProjectPage DocsPage UnderDevelopment MembersPage SiteIndex RecentChanges Preferences
History of GenBoard/BuildProcedures/LCDconnect
Older Newer
2019-05-15 09:09:06 . . . . 92-249-172-71.pool.digikabel.hu [negative contrast is rare]
2016-01-16 20:18:24 . . . . h143n9-ksg-a11.ias.bredband.telia.com [updated a dead link to datasheet for blue LCD]
2014-01-06 09:34:35 . . . . catv-80-98-222-153.catv.broadband.hu [Emphasize link to nice drawing]
2012-11-05 15:38:19 . . . . adsl12-231.pool.businesstel.hu [minor: Vcc = +5V]
2011-12-29 10:26:50 . . . . adsl5-237.pool.businesstel.hu [warning: do NOT connect RS232 into the LCD connector]
2010-09-21 12:04:08 . . . . 53d83346.adsl.enternet.hu [LCD image ]
2008-05-16 23:30:24 . . . . 237.198.8.81.ac-net.se [Link to red display, removed old pinout]
2007-05-20 13:50:07 . . . . MembersPage/MattiasSandgren [Added picture of JP_LCD pinout]
2006-06-15 07:19:53 . . . . MembersPage/MarcellGal [linked datasheet]
2006-06-05 23:52:45 . . . . MembersPage/MarcellGal [linked Peter Jensen's page]
2005-10-16 15:24:53 . . . . MembersPage/MarcellGal [note about -8V : negative contrast not needed for most LCD]
2005-09-12 00:31:18 . . . . MembersPage/MarcellGal [LCD DSUB9 new pinout]
2005-07-20 22:49:32 . . . . MembersPage/MattiasSandgren [Proposed pinout for keyboard through DB25]
2005-07-12 21:15:37 . . . . MembersPage/MarcellGal [busypoll notes: disabling busypoll not recommended]
2005-07-09 00:38:28 . . . . MembersPage/MarcellGal [proposed "natural" pinout]
2005-05-25 16:43:05 . . . . MembersPage/MarcellGal [s/blue/darkblue/ since the 12-wire loom also has a light-blue]
2005-04-13 16:42:58 . . . . MembersPage/MarcellGal [recommended colors]
2005-02-12 19:24:55 . . . . MembersPage/FredrikJagenheim [Added picture, hopefully it's not incorrect]

Changes by last author:

Changed:
* LCD contrast: there are onboard SMD resistor pads for setting LCD contrast bias, but adjusting this with resistors at the LCD is recommended: to allow swapping between different makes of LCD
* LCD contrast: there are onboard SMD resistor pads for setting LCD contrast bias, but adjusting this with resistors at the LCD (or heatshrinked inside LCD cable) is recommended: to allow swapping between different makes of LCD
Changed:
LCD that requires a negative (appr. -3V) contrast voltage.
LCD that requires a negative (appr. -3V) contrast voltage (very rare among those manufactured after 2012).