______ 
| ___ \
| |_/ /
|  __/ 
| |    
\_|    
       
       

         
  ####   
 ##  ##  
 ######  
 ##      
 ##      
  ####   
         

 ___   
(  _`\ 
| ( (_)
| |___ 
| (_, )
(____/'
       
       

     #   
         
    ##   
     #   
     #   
     #   
 #   #   
  ###    

 ###     
  ##     
  ##  ## 
  ## ##  
  ####   
  ## ##  
  ##  ## 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Vems Round can be configured to have 1 to 8 display slot '''S-0 to S-7''', * possibly '''switchable via button''' or analog input signal. ** usually switchable, but can be disabled: depends on analog input configuration, eg. analog input threshold * any '''display slot can be configured to show anything, including blank''' If the displayed data is questioned or weird, '''try to switch display slot with the button. S-0 is most often configured to show lambda and EGT''' (but again: this is configurable). If still not as expected, connect VemsTune via [http://vems.hu/vt/help/round/round_hardware.html RS232 interface]. * check that the data is correct (eg. lambda, EGT, RPM or analog input or other data of concern) * check wiring and related configuration (EGT calibration, WBO2 calibration, ...) if readings are uncertain ---- '''Boot mode detected "Bad marker (0x34)"''' means fw integrity is uncertain, (perhaps after unsuccessful firmware upload) => '''"Stay".''' * note: "Leave" will try to run the firmware anyway. May or may not work, but most likely "Boot mode" happens for every boot, which can be inconvenient. To upload firmware, Simply "Stay" and: ''' "Tools / upload firmware"''' (matching the device, eg. 1.5.8). See AfreshTiny/FirmwareUpgrade '''File / Save previous config.''' '''Upload new config if necessary''' (might not be necessary if fw version is same or very close). * check [http://vems.hu/vt/help/round/round_dialogs.html display settings] ---- Serialnumber > 32000 see RoundV21 If display shows "-FU", see RoundV21/IssueFu
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.