## ## ##### ## ## ## ## ## ##
_ _ | \ | | | \| | | . ` | | |\ | |_| \_|
# # # # # ## ### # # ####
#### ## ## ## ####
##### ## ## ## ## ##### ## #####
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: I'll document my progress on the InputTrigger/NissanTrigger Helper Board here. This is my current table setup: http://jagenheim.se/TestSetup.jpg The chip is the AtTiny2313. The (ugly) schematic: http://jagenheim.se/nissan_trigger.png (I didn't have a AtTiny2313 component, thus the older AT902313.) The code is [http://jagenheim.se/nissan_trigger.c here]. It will light up the corresponding green LED. I've never seen the LED used for decoding errors light up. Can you elaborate on the * purpose of LM2917 ? * Link datasheet * alternative solutions * etc.. ---- '''TODO:''' * decide about the input-capture pin. Why isn't input capture utilized ? * prefer a non-EOL (not obsolete) chip * Integrate a LM2917 chip (for the tachometer) ** This doesn't seem to work properly. If I tap the signal with the LM2917 chip, the trigger won't work. Probably changing the electric levels with the chip connected. ** Can anyone think of another way to get the tachometer output? * Change output to simple trigger + cam sync * Get input on the solution * Make a real board * ????? * Profit!!! Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.