_____ |_ _| | | | | | | \_/
_ __ | |/ / | ' / | < | . \ |_|\_\
_____ | ___| | |__ | __| | |___ \____/
##### ## ## ## ## ##### ## ##
___ / _ \ | | | | | |_| | \___/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: - M50B25 stock bottom (BMW Inline 6 cyl 2.5 lit 24 valve) - Cooperring headgasket w/ ARP studs - Puls-split ex. manifold - TB70-03 turbo from Turbobanditen - HKS 40mm Wastegate - 3" downpipe and ex-system. 100 cell racecat + 1 muffler. - M20 Flywheel + 618 pressureplate + 6-p Sinter - FmIC 600x300x75mm - Greddy 40mm BOV - 980cc High Z Siemens Injectors - Malpasi fuel pressure regulator - Dual Walbro intank fuelpumps 255Lph - Built in ignition IGBT of the Genboard 3.6 and the stock coils of the M50B25 in a wasted spark config - Firmware 1.1.95 - VEMS Genboard 3.6, Custom adapter-harness from Vems-->Motronic 88. (No wiring needed, just remove your motronic/siemens ECU and mount the harness and Vems ECU) Motronic Connector came from an old M50 ECU. - BMW M50 Non-vanos 60-2 VR stock trigger. - Cam trigger not used or needed for a wasted spark setup - All other sensors also stock bmw M50. - Stock air mass meter removed - I did the Config setup myself. Tuned to about 240kpa now with good economics on light load(also running on closedloop lambda) and good performance on high load. Tuned on a Dynapack dyno with 611whp and 746Nm. You'll find an early version, NOT FULLY TUNED, config file here: http://www.vems.hu/files/ProTaz/M50B25_nonvanos_dual_intakecams_K29_980cc_wastedspark.vemscfg A picture of the adapter-harness not entirely completed: http://www.vems.hu/files/ProTaz/M50%20to%20Vems%20Adapter.jpg PIN numbers for the adapter can be provided if wanted. Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.