### ## ## ## ## ## ####
_ ( \ | ( | | | | | | | (____/\ (_______/
##### ## ## ## ## ## ## ## ##
_ _ ( ) ( ) | | | | | | | | | (_) | (_____)
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: - M50B25 stock bottom - 3,5mm MLS + ARP - Puls-split ex. manifold - KKK K29 #16 (Prev: Holset HX40 #14) - HKS 40mm Wastegate - 3" downpipe and ex-system. 100 cell racecat + 1 muffler. - M20 Flywheel + 618 pressureplate + 6-p Sinter - FmIC 600x300x75mm - Greddy 40mm BOV - 980cc High Z Siemens Injectors - Malpasi fuel pressure regulator - Henko intank fuelpump 255Lph - ignition transformer ? 3 or 6 ? What type ? Requires logiclevel or power output? * I use the built in ignition IGBT of the Genboard 3.6 and the orig coils of the M50B25 in a wasted spark config.(also known as dual spark setup i belive) - VEMS Genboard 3.6, Custom adapter-harness from Vems-->Motronic 88. (built it my self) (No wiring needed, just remove your motronic/siemens ECU and mount the harness and Vems ECU. '''Where did you buy the motronic-88 male connector''' ? Does it have a codename or Tyco product number ? Is it wire-wire or wire-board (mount-on-PCB) type connector ? *I took the connector from orig ECU that came with my car. Looking for engine constants settings parameters for the M50 non-Vanos. * Trigger settings: upload standard M20 60-2 6 cyl configlet from primary trigger dialog: ** trigger_tooth around 4 with ign_tdcdelay~60 degrees (but strobe anyway) * I did my config myself with a bit of trial and error. Tuned to about 240kpa now with good economics on light load and good performance on high load. Pretty sure there's more power to gain with a bit more tuning, but i'm pretty pleased right now. Tire slip on 3rd gear when putting the hammer down.(dry road, 265/40/17 eagle F1 tire and LSD diff.) Will try to post my config when I know how to do it... ;-) The same goes for some pictures of my adapter harness and install. Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.