___ ( _`\ | (_(_) | _) | | (_)
_ _ ( ) ( ) `\`\_/'/' `\ /' | | (_)
___ ___ | \/ | | . . | | |\/| | | | | | \_| |_/
_ _ ( ) ( ) | | | | | | | | | \_/ | `\___/'
______ | ___ \ | |_/ / | ___ \ | |_/ / \____/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: [MembersPage/JanSaenen] Current state: Used MembersPage/PhatBob/UserGuide and Firmware .38 I'm using a BMW M20 6 cylinder engine simular to MembersPage/GergelyLezsak It uses the following sensors and injectors: *440CC injectors Bosch *Stock single coil distributer *VEMS Internal Map sensor (working) *VEMS shop IAT sensor (working) *WB02 5057 sensor (working) *Other CLT sensor (working) *Volvo TPS sensor (working) *Stock VR sensor (working) ---- ''''16-06-06'''' Trying to figure out the primary triggger settings. This brings some questions along. '''*What tooth is considered the first one?''' Is this the one after the 2 missing ones? So the first missing one would be nr 59 and the sencond one being nr 60 on a 60-2 wheel-setup. '''*What is ment by the next trigger tooth?''' Is this the tooth where the next cilinder is at TDC? '''*What is ment by angular width to reset the enginefase?''' I don't have a cam sensor and it's a four-stroke 6 cilinder engine. So my firing order has to be reset after 720 degrees. Cilinder 1 at 0 degrees, Cil 5 at 120 degrees .......... Cilinder 4 at 600 degrees and Cil 1 again at 720 degrees. '''*What is ment by angular width of tooth?''' Is this 360/60=6 degrees or the actual tooth width which is approx 2 degrees? Based on this my primary trigger settings should be: *Rising *Multitooth *Disabled *Disabled *Disabled *Disabled *62 (deg) TDC after the trigger If tooth 1 is the first rising edge after the two missing ones. *58 Number of teeth on wheel *5 Trigger tooth If tooth 1 is the first rising edge the sensor sees after the two missing ones. *20 Next trigger tooth *2 Angular width of tooth *121 Tooth rel normal (Not relevant) *181 Tooth rel missing (Not relevant) *6 Angular width of missing tooth *720 engine fase, when to reset But this doesn't comply with what I've seen at other maps from people with the same engine. Especially the next trigger tooth is different. ---- '''IAT and CLT:''' [/MembersPage/JanSaenen/Tempsens] ---- ''''Fuelpump'''' [/MembersPage/JanSaenen/Fuelpump] Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.