##    
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

   ____ 
  / ___|
 | |    
 | |___ 
  \____|
        

 _ 
(_)
| |
| |
| |
(_)
   
   

 _______ 
(       )
| () () |
| || || |
| |(_)| |
| |   | |
| )   ( |
|/     \|
         

         
    ##   
         
    ##   
    ##   
    ##   
    ##   
 ####    

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I have a car with Magneti Marelli cam (VR?) sensor(very hard to modified cam sensor), 3 sectrig teeth. [http://www.vems.hu/files/DamirMuha/v3.3_n002476-2011-01-27-17.37.13.zip Trigger log zip] Write position of sectrig pulses, please ! * primary trigger is 60-2 (trigger tooth=9 64deg before tdc). ** If vems ignore sectrig pulses in range 130-150deg before TDC that leaves only one pulse per cam rotation. '''Proposal''' * add code to sec trigger, if sec trigger is in range of min and max sectrigger angle then that pulse is ignored. ** when the camsync is detected, we do NOT have cam-referenced position angle. We only have primtrig toothcount (with missing tooth wheel) ** tooth0 is the tooth after missing gap, 0..57 are the toothnums for 60-2. Can you rephrase your page that way ? ** 9*6 + 64 + (360-130) = 348 (tooth 58 ?) ** 9*6 + 64 + (360-150) = 328 ( tooth 54 ?) Should there be some config.secignore to ignore camsync that comes at primtrig toothcnt > config.secignore ? (default 255 disables it). Note that it doesn't matter if many sectrig pulses come, as long as all those pulses are in the same crankshaft rotation (starting at tooth0 of course, NOT TDC) they don't cause operational problem with missing tooth primary trigger wheel (if camsync bad position is configured to flag only, not to cut spark). * Yes, ignore sec trigger if toothcnt > config.secignore whould be good and also good for cosworth cam sensor. ---- Well it would be good for the modified Cosworth, which using 36-1 crank trigger wheel, but need to use the original 2-tooth secondary trigger! * imho not, becouse orginal cosworth has two impulses 180deg(90deg on cam) forked. ** And is it too much to ignore one of them? (Marcel said that in cosworth trigger setup the algorythm ignore one of the two impulse - so is not possible with 36-1?)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.