__          __
 \ \        / /
  \ \  /\  / / 
   \ \/  \/ /  
    \  /\  /   
     \/  \/    
               
               

  _____  
 |  __ \ 
 | |  | |
 | |  | |
 | |__| |
 |_____/ 
         
         

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 #####   
         

_________
\__    _/
   )  (  
   |  |  
   |  |  
   |  |  
|\_)  )  
(____/   
         

 ___   
(  _`\ 
| ( (_)
| |___ 
| (_, )
(____/'
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Similar to * MembersPage/RicoZiemer I want to buy VEMS and put it to my BWM E28 528i '84 with a M30B28 engine running L-Jetronic engine managment. I want to keep an original sensors, wires etc. I have intention to order Assembled v3.3 controller in this setup: * 1-wire interface: NO * Flyback: 30V * ignition driver: 0 ** are you sure about this ??? 6 IGBTs allow you to use up to 6 power outputs, or upto 6 logiclevel (2 from i259 + 4 stepper outputs) * Knock and EGT: YES (with second knock sensor input wire to * EC18pin2) * LCD connection: YES * MAP connection: 400kPa (6/4mm pneumatic) * mounting-style: NO-SCREWS * PS2 connection: NO * primary_trigger: VR * secondary_trigger: AUDITRIGGER I hope, that the configuration what I chose will allow me to trouble-free connect and start VEMS. ---- '''Trigger''' To verify VR, Please measure inputtrigger resistance of both sensors. Should be same (usually 400..1300 Ohm) in both directions. * measured primary trigger resistance = ... '''FILL THIS IN''' * measured secondary trigger resistance = ... '''FILL THIS IN''' ---- I need some help on my project, thank you.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.