_______ ( ___ ) | ( ) | | (___) | | ___ | | ( ) | | ) ( | |/ \|
## ## ## ## ## ## ##### ## ####
## ## ####### ####### ## # ## ## ##
_____ / ____| | | __ | | |_ | | |__| | \_____|
__ __ | \/ | | \ / | | |\/| | | | | | |_| |_|
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: = Notes = MembersPage/AntonLilja ---- '''Outputs''' The FET and IGBT places on the board can be assigned with much freedom. See GenBoard/Manual/DigitalOut, GenBoard/Manual/DigitalOut/Table * injectors => injector outputs * ignition => ignition outputs (logiclevel for active coils; IGBT based power outputs for passive coils) * bipolar stepper (if used) => stepper outputs * other outputs => after assigning the above use the remaining outputs. take care about current rating and flyback protection (eg. WBO2 second channel FET and DPAK "extraFET"-s have no flyback installed by default!) ** Use the higher current stuff first for more safety ** except for (low current like) LEDs (like shiftlight), where p259 outputs are the best ** don't forget flyback and GND and GND5 connections Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.