__          __
 \ \        / /
  \ \  /\  / / 
   \ \/  \/ /  
    \  /\  /   
     \/  \/    
               
               

 ###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ###  ## 
         

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

         
         
  ####   
 #    #  
 #    #  
 #    #  
  ####   
         

         
|\     /|
( \   / )
 \ (_) / 
  \   /  
   ) (   
   | |   
   \_/   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
turbocharged 1993 VW air cooled Mexican bug Hi from Mexico Hi im loocking for used vems round v3.x Serialnr: ..... (or orderid ... )Order Number: 5839 Its Alive and running in my 1993 VW bug (vocho here in Mexico) 1585cc OEM engine with k03 turbo charged air water intercooler best ET in 1/4 mile 16.3 sec, with out turbo ran 20 seconds!! regards '''Short history of the board''' * was purchased as assembled or mainboard ? MAINBOARD * ... * I ask for the firmware for my board because '''by mistake I connected a temp sensor input to the 12v line''' ** ouch. First, '''If all the GND-s are OK, then 12V on the MAT or CLT input should not be fatal (it might not cause any damage)'''. Or was it K-thermocouple (EGT) input ? ** But if GND-s are not OK (or come off, or EC36 disconnected during powerup) that can be a problem, and firmware upgrade is very unlikely to solve the problem (it cannot cure if HW is damaged). I have a few problems with my genboard. When run VemsTune the software detect the board but pop up a window with legend device disconnected and the firmware upload menu is in grey color * Verify the RS232 connection, document here your wiring and voltage measurements: ** DSUB9/2 - ... ** DSUB9/3 - ... ** DSUB9/5 - ... Another thing the volt reg u20 gets very hot and the mosfet drivers gets warm * this sounds bad ** verify (measure) polarity and supply voltage: ... V ** measure current consumption: ... mA Make sure to follow instructions. * is there a chance +12V power was applied without grounds connected properly ? ** we've seen a case this year when GND came off (!) while +12V was applied (so powering GND through some FET outputs and atmega inputs => not good). This is also the reason why disconnecting EC36 under powerup is not allowed (damage is too likely). See grounds connection: http://vems.hu/download/v3/doc/ConnectingPower4.jpg For assembled board, see relevant info http://vems.hu/download/v3/doc/ (also useful for home-assembled box unless one intentionally deviates)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.